Changing Paper Roll; Training Mode - VeriFone VX 680 User Manual

Changing Paper Roll

1. Hook your finger under the latch on the rear of the terminal and lift up to swing the paper roll cover
open.
2. Remove any partial roll of paper in the printer tray by lifting it up.
3. Loosen the glued leading edge of the new paper roll or remove the protective strip. Unwind the paper
roll past any glue residue.
4. Hold the roll so the paper feeds from the bottom of the roll.
5. Drop the paper roll into the printer tray.
6. Pull paper up past the glue residue.
7. Close the paper roll cover by gently pressing directly on the cover until it clicks shut, allowing a small
amount of paper past the glue residue to extend outside the printer door.
8. Tear the paper off against the serrated metal strip in the printer.
www.firstpaymentmerchantservices.co.uk
Page 4

Training Mode

Before using the terminal for live transactions we advise that you take 5 minutes to familiarise yourself by
processing some transactions in Training Mode. Please follow the instructions below to switch the terminal
in/out of Training Mode.
From the idle screen, press the downward arrow at the bottom of the screen
until the 'Supervisor' option is displayed.
Select the Supervisor mode by pressing the relevant option on the screen.
Key in the Supervisor password and press the green Enter button.
Select the 'Training' option.
www.firstpaymentmerchantservices.co.uk
Page 5
6