Setting The Snmp Agent - Fujitsu ETERNUS LT160 User Manual

Remote Panel Operation
5.5.6

Setting the SNMP agent

The following explains how to set the SNMP agent required for communication with the
SNMP manager.
1) Click the [SNMP] button displayed under [Setup]. The following window will be
2) Set each item.
Community
Trap Destination IP
Address
Enable Send Trap
5-40
displayed.
If the SNMP agent is already set, its values are displayed.
Figure 5.29 SNMP agent setting window
Display item
Up to five communities set by the SNMP manager can be
registered. Though up to 64 characters can be entered in
each text area, only one community can be set in one text
area. Characters that can be entered are en-size
alphanumeric characters and en-size symbols
(!"#$%&'()*+'-./:;<=>?@[\]^_`{|}). To remove a setup
community already set, delete the relevant community.
Traps will be sent to the IP address specified here. Only
en-size numeric characters ranging from 0 to 255 can be
entered in each text area of this item.
If checked, Traps will be sent to the IP address specified
Explanation
C144-E072-01EN