Error Log Entries And Test To Clear Values - Avaya G250 Maintenance Manual

Avaya Communication Manager controlled maintenance

Error Log Entries and Test to Clear Values

Table 69: DIOD Trunk Error Log Entries
Error Type
0*
15 (b)
18
769 (a)
1537 (f)
2561 (a,d)
2817 (a,e)
3073 (a,c)
3585 (a,c)
*Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
**Major alarms on this MO may be downgraded to Warning alarms based on the value used in
the set options command. If the Minor alarm is not downgraded by the set-options values, the
Minor alarm is upgraded to a Major alarm if 75 percent of the trunks in this trunk group are
alarmed.
Notes:
(a) These are in-line errors that have no specific test associated with them. Refer to the
●
following
explanation and appropriate action.
(b) This is a software audit error and does not indicate any hardware malfunction. Run the
●
Short Test Sequence and investigate associated errors.
(c) These errors cause the Dial Tone Test (#0) to run and are only considered a problem if
●
the Dial Tone Test fails (in which case Error Type 1537 also appears). In this case, the
trunk may be put in "Ready-for-Service" state (shown as "disconnected" by status
command), which allows only incoming calls. Run the Dial Tone Test (#0) and follow its
procedures.
Aux data 57376—No loop current on incoming call
Aux data 57424—No loop current on outgoing call
162 Maintenance for the Avaya G250 and Avaya G350 Media Gateways
Aux Associated Test
Data
0 Any
any Port Audit Update
Test (#36)
0 Busyout trunk grp/
mbr
57392 None
57345 None
57393 None
57376 None
57424 None
Table 70: DIOD Trunk Errors without Associated Tests
Alarm Level
Any
WARNING
MAJ/MIN/WRN**
On/Off Test to Clear
Board Value
Any test port sh
release trunk
ON
on page 163 for an