Avaya G250 Maintenance Manual page 116

Avaya Communication Manager controlled maintenance
Table 43: TEST #36 Port Audit and Update Test (continued)
Error Test
Code Result
PASS
Any NO
BOARD
116 Maintenance for the Avaya G250 and Avaya G350 Media Gateways
Description/ Recommendation
Trunk translation has been updated successfully. The current trunk
states kept in the DS1 Interface media module and switch software are
consistent. If the trunk is busied out, the test will not run but will return
PASS. To verify that the trunk is in-service:
Enter status trunk to verify that the trunk is in-service. If the trunk is
in-service, no further action is necessary. If the trunk is out-of-service.
Enter release trunk to put the trunk back into in-service.
Retry the test command.
The test could not relate the internal ID to the port. This result could be
due to incorrect translations, no board inserted, an incorrect board
inserted, an insane board inserted, or the board is hyperactive.
Check to ensure that the board translations are correct. Use the list
config command, and resolve any problems that are found.
Use the busyout board command.
Use the reset board command.
Use the release busy board command.
Use the test board long command.
This should re-establish the linkage between the internal ID and the
port. If not, to check that there is a valid board inserted.
Hyperactivity causes some special problems with the sequence
suggested above. If the ports are translated after issuing the list config
command but the 'Vintage' field reports that there is no board (when
there really is a board), then the busyout board and the release busy
board commands do not work (even though the reset board command
does work). The software puts the hyperactive board back in service
after the hyperactivity clears.
2 of 2