Port Audit And Update Test (#36) - Avaya G250 Maintenance Manual

Port Audit and Update Test (#36)

This test sends port level translation data from switch processor to the DS1 Interface media
module to assure that the trunk's translation is correct. Translation updates include the following
data: trunk type (in/out), dial type, timing parameters, and signaling bits enabled. The port audit
operation verifies the consistency of the current state of trunk.
Table 43: TEST #36 Port Audit and Update Test
Error Test
Code Result
ABORT
1000 ABORT
1006 ABORT
2000 ABORT
2100 ABORT
FAIL
Description/ Recommendation
Internal system error
Retry the command at 1-minute intervals for a maximum of 5 times.
System resources required to run this test were not available. The port
may be busy with a valid call.
Use display port GGGVSPP to determine the trunk group/member
number of the port. Use the status trunk command to determine the
service state of the port. If the port is in use, wait until the port is idle
before testing.
If the port status is active but the port is not in use (no calls), check the
error log for error type 1025. The port may be locked up.
If the port status is idle, retry the command at 1-minute intervals for a
maximum of 5 times.
The DS1 CO trunk is out of service.
Use status trunk to verify that the trunk is out of service.
If the trunk is out of service, determine why.
If it is OK to put the trunk back in service, use the release trunk
command to put the trunk back in service, and then retry the test.
Response to the test was not received within the allowable time period.
Could not allocate the necessary system resources to run this test.
Retry the command at 1-minute intervals for a maximum of 5 times.
Test failed due to internal system error.
Retry the command at 1-minute intervals for a maximum of 5 times.
CO-DS1 (DS1 CO Trunk)
1 of 2
Issue 1.1 June 2005 115