Avaya G250 Maintenance Manual page 105

Table 36: TEST #35 Battery Feed Test (continued)
Error Test
Code Result
1392 ABORT
2000 ABORT
2100 ABORT
FAIL
Description/Recommendation
This port is currently a TTI port and the test does not execute on it.
Verify that the port is a TTI port:
Enter the display port GGGVSpp command (the display shows that
the port is a TTI port).
Enter the list configuration command (the display shows a t for the
port).
If both commands indicate that the port is a TTI port, the abort is
correct for the test, and no action is necessary.
If either command indicates that the port is not a TTI port, escalate the
problem.
Response to the test request was not received within the allowable
time period.
System resources required to run this test are not available.
Retry the command at 1-minute intervals no more than 5 times.
If the test continues to abort, escalate the problem.
The port's battery feed chip is unable to supply sufficient power to the
terminal equipment. This test result might be marginal, and the
terminal equipment may be operating satisfactorily.
Retry the command at 1-minute intervals no more than 5 times.
If the test continues to fail, determine whether the customer is
experiencing problems on this line. Replace the media module only if
the customer is experiencing problems.
AN-LN-PT (Analog Line Port)
2 of 3
Issue 1.1 June 2005 105