Avaya G250 Maintenance Manual page 36

G250/G350 component maintenance
To place a test call:
1. Dial the Feature Access Code (FAC) described above and listen for dial tone.
2. If the trunk is on an S8700/S8710 PN port, dial the 7-digit port location UUCSSpp, where:
- UU = Cabinet number (01 - 44 for PNs)
- C = Carrier number (A = 1, B = 2, C = 3, D =4, E = 5)
- SS = Slot number (01 - 20)
- pp = Port circuit number (01 - 24)
The channels on a DS1 trunk are addressed by using the channel number for the port
number.
3. If the trunk is on a G350 MM710 media module, dial the 7-digit port location MMMVXyy,
where:
- MMM = Media Gateway number: 3 digits [0 - 9] [0 - 9] [0 - 9]
- V = Gateway port identifier carrier = 8
- On a telephone keypad, the number "8" also displays the letters "T", "U", and "V".
- X = Slot number (1 - 5, if no S8300/LSP in Slot 1)
- yy = Circuit number
Circuit range depends upon the media module on which the trunk is set up. For the Avaya
Analog media module (MM711), the range is 1-8; for the Avaya E1/T1 media module
(MM710), the range could be 1-23, 1-24, 1-31, or 1-32, depending upon the type of
translation and signaling.
Example: If the CO trunk is on port 5, MM in slot 3, of MG 34,
dial FAC
get dial tone
dial 0348305
36 Maintenance for the Avaya G250 and Avaya G350 Media Gateways