Avaya G250 Maintenance Manual page 181

Table 83: TEST #639 Secondary Signaling Link Hardware Check
Error Test Result
Code
ABORT
1132 ABORT
8 FAIL
PASS
Any NO
BOARD
Description/ Recommendation
Internal system error
Retry the command at 1-minute intervals a maximum of 5 times.
The Secondary D-Channel is not administered for this Signaling
Group. This is a NORMAL ABORT. Only a Primary D-Channel must be
administered for a Signaling Group.
There is a problem with the MM710 or the ISDN-PRI Secondary
Signaling Channel (D-Channel). No ISDN trunk or PRI endpoint calls
can be made until the problem is resolved.
Consult the procedures for the MM710 and the ISDN-PRI Signaling
Channel (ISDN-LNK).
The basic physical connectivity of the Signaling Group's Secondary
D-channel is intact and functional. Try this test repeatedly to ensure
the link is up and to uncover any transitory problems.
The test could not relate the internal ID to the port (no board). This
could be due to incorrect translations, no board is inserted, an
incorrect board is inserted, or an insane board is inserted.
Ensure that the board translations are correct. Execute the add ds1
GGGVS command to administer the MG-DS1 interface if it is not
already administered.
If the board was already administered correctly, check the error log to
determine whether the board is hyperactive. If this is the case, the
board is shut down. Reseating the board will re-initialize the board.
If the board was found to be correctly inserted in step 1, then use the
busyout board command.
Use the reset board command.
Use the release busy board command.
Use the test board long command.
This should re-establish the linkage between the internal ID and the
port.
ISDN-SGR (ISDN-PRI Signaling Group)
Issue 1.1 June 2005 181