Avaya G250 Maintenance Manual page 286

G250/G350 traps
Table 129: G250/G350 Traps and Resolutions (continued)
Enterprise Trap
ID
avEntTraps 8
avEntTraps 11
avEntTraps 14
avEntTraps 17
avEntTraps 20
avEntTraps 22
286 Maintenance for the Avaya G250 and Avaya G350 Media Gateways
Name
avEnt5vPwrFltOk
avEnt3300mvPwrFltOk
avEnt2500mvPwrFltOk
avEnt1800mvPwrFltOk
avEnt1600mvPwrFltOk
avEntAmbientHiThresholdTempFlt
Msg Severity Description / Resolution
Facility
Supply The problem with the 5V power supply has
been corrected.
Supply The problem with the 3.3V power supply
has been corrected.
Supply The problem with the 2.5V power supply
has been corrected.
Supply The problem with the 1.8V power supply
has been corrected.
Supply The problem with the 1.6V power supply
has been corrected.
Temp The ambient temperature in the device is
above the acceptable temperature
range.
If no media module is found to be bad, the
power supply is suspect. Replace the
G250/G350.
1. Verify there are faults in the
system. Use the Avaya G250/G350
Media Gateway CLI command
show faults to display any faults on
the G250/G350.
2. If there is a temperature fault, turn
off the G250/G350 and allow it to
cool.
3. Reboot the G250/G350. Check to
see if the fans are working and/or if
there is sufficient space around the
G250/G350 for air circulation. Use
the CLI show faults command to
check for fan problems.
4. Low voltage may be responsible for
slower fans. Voltage may be
reduced by a short in one of the
media modules or a bad power
supply. If there are no fan faults,
use the CLI command show
voltages to display voltages
applied to components on the
motherboard and to the media
modules.
5. If the media module voltage is out
of tolerance, systematically,
remove each media module to
determine if one of the media
modules is responsible for
reducing the voltage level. If one is
found, replace the media module.
5 of 16