Removing The Virtual Media Key - Lenovo TD200 - ThinkServer - 3809 Hardware Maintenance Manual

1
Power supply support bracket
2
Power supply release tab
Step 21. If you have other options to install or remove, do so now.
Step 22. Replace the side cover (see "Installing the side cover" on page 252). Go to "Completing the
installation" on page 249.

Removing the virtual media key

To remove the virtual media key, complete the following steps:
Step 1. Read the safety information (see Chapter 2 "Safety information" on page 3).
Step 2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables.
Unlock and remove the side cover (see "Removing the side cover" on page 146).
Step 3. Carefully lay the server on its side so that it is lying flat and facing up.
Note: Do not allow the server to fall over.
Step 4. Rotate the rear adapter-retention bracket to the open (unlocked) position.
Step 5. Remove any adapters that prevent you from accessing the virtual media key connector on the
system board (see "Removing an adapter" on page 217).
Step 6. Press outward on the retention tab and pull the virtual media key out of the connector.
1
Alignment bracket
2
Virtual media key (rear)
3
Virtual media key (front)
4
Retention tab
5
Virtual media key connector
244
ThinkServer TD200 Hardware Maintenance Manual
Do not insert a memory DIMM in this connector. This DIMM slot is not supported in this model.
Do not insert a memory DIMM in this connector. This DIMM slot is not supported in this model.
Do not insert a memory DIMM in this connector. This DIMM slot is not supported in this model.
Do not insert a memory DIMM in this connector. This DIMM slot is not supported in this model.