Removing a simple-swap hard disk drive
Attention: Simple-swap hard disk drives are not hot-swappable. Disconnect all power from the server
before removing or installing a simple-swap hard disk drive.
To remove a simple-swap hard disk drive, complete the following steps.
Step 1.
Read the safety information (see Chapter 2 "Safety information" on page 3).
Step 2.
Turn off the server and all attached devices; then, disconnect all power cords and external cables.
Step 3.
Unlock the side cover.
Step 4.
Open the bezel. Place your finger on the pull point area on the left side of the bezel door and
rotate it away from the server.
Step 5.
Grasp the tab on the drive bay EMC shield and rotate it to the open position.
.
Chapter 7
Installing and replacing FRUs
179