Connecting The Cables - Lenovo TD200 - ThinkServer - 3809 Hardware Maintenance Manual

1
Cover release latch
2
Lock
3
Left-side cover
To reinstall the side cover, complete the following steps:
1. Make sure that all cables, adapters, and other components are installed and seated correctly and that
you have not left loose tools or parts inside the server. Also, make sure that all internal cables are
correctly routed.
2. Insert the bottom edges of the cover onto the inside lip of the chassis and rotate the cover toward
the server.
3. Press down on the cover-release latch and close the cover to secure it in place.
4. Lock the side cover.
Note: When you lock the server side cover, it locks both the cover and the bezel.

Connecting the cables

Attention: To prevent damage to equipment, connect the power cords last.
If the server cables and connector panel have color-coded connections, match the color of the cable end
with the color of the connector. For example, match a blue cable end with a blue panel connector, a red
cable end with a red connector, and so on.
The following illustration shows the input/output (I/O) connectors on the rear of the server.
.
Chapter 7 Installing and replacing FRUs
253