Lenovo TD200 - ThinkServer - 3809 Hardware Maintenance Manual page 127

Table 4. DSA Preboot messages (continued)
• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See Chapter 8 "Parts listing, TD200 Machine Types 3724, 3808, 3809, 3815, 3817, 3824, 3826, 3836" on page
257 to determine which components are customer replaceable units (CRU) and which components are
field replaceable units (FRU).
• If an action step is preceded by "(Trained service technician only)," that step must be performed only by
a Trained service technician.
• Go to the Lenovo support Web site at http://www.lenovo.com/support/ to check for technical information,
hints, tips, and new device drivers or to submit a request for information.
Message
number Component Test
264-905-xxx Tape Drive
264-906-xxx Tape Drive
State
Tape Drive Test Failed
Tape Drive Test Failed
Description Action
Software error: 1. If the system has stopped
responding, turn off and restart the
invalid request.
system and then run the test again.
2. Check system firmware level and
upgrade if necessary. The installed
firmware level can be found in the
DSA Diagnostic Event Log within
the Firmware/VPD section for this
component.
3. Run the test again.
4. If the system has stopped
responding, turn off and restart the
system.
5. If the failure remains, go to
the Lenovo Web site for more
troubleshooting information at
http://www.lenovo.com/support.
Unrecognized
1. Clean the tape drive using the
error. appropriate cleaning media and
install new media.
2. Run the test again.
3. Clear the error log.
4. Run the test again.
5. If the failure remains, go to
the Lenovo Web site for more
troubleshooting information at
http://www.lenovo.com/support.
119
.
Chapter 5 Diagnostics