Removing A 3.5-Inch Hot-Swap Hard Disk Drive - Lenovo TD200 - ThinkServer - 3809 Hardware Maintenance Manual

3
Drive tray handle (in open position)
4
Release latch
5
Hard disk drive
Step 5. Make sure that the tray handle is open.
Step 6. Align the drive assembly with the guide rails in the bay.
Step 7. Push the drive into the bay until the drive stops.
Step 8. Push the tray handle to the closed (locked) position.
Step 9. Check the hard disk drive status indicator to make sure that the hard disk drive is operating
correctly.
After you replace a failed hard disk drive, the green activity LED flashes as the disk spins up. The
amber LED turns off after approximately 1 minute. If the new drive starts to rebuild, the amber
LED flashes slowly, and the green activity LED remains lit during the rebuild process. If the
amber LED remains lit continuously, the drive is faulty and must be replaced. See Chapter 5
"Diagnostics" on page 21.
Note: You might have to reconfigure the disk arrays after you install hard disk drives.
Step 10. Close the bezel.
Step 11. Lock the side cover.

Removing a 3.5-inch hot-swap hard disk drive

Attention: To maintain proper system cooling, do not operate the server for more than 10 minutes without
either a drive or a filler panel installed in each drive bay.
To remove a 3.5-inch hot-swap SAS or hot-swap SATA hard disk drive, complete the following steps.
Step 1. Read the safety information (see Chapter 2 "Safety information" on page 3).
Step 2. Unlock the side cover.
Step 3. Open the bezel. Place your finger on the pull point area on the left side of the bezel door and
rotate it away from the server.
176
ThinkServer TD200 Hardware Maintenance Manual