Opening And Closing The Bezel Media Door - Lenovo TD200 - ThinkServer - 3809 Hardware Maintenance Manual

1
Bezel
2
Hinge assembly
3
Retention tabs
Note: The bezel will also disengage from the chassis hinges if you rotate the bezel beyond 180° or
if excessive pressure is applied to the bezel. Do not be alarmed because this is how the bezel was
designed. The bezel is designed with breakaway hinges so that you can easily reattach it to the chassis.

Opening and closing the bezel media door

To open the media door, complete the following steps:
1. Read the safety information (See Chapter 2 "Safety information" on page 3).
2. Unlock the side cover.
Note: You must unlock the side cover to open or remove the bezel. When you lock the server side cover,
it locks both the cover and the bezel.
3. Grasp the pull-point area on the left side of the bezel door and rotate the bezel to the open position.
4. From inside of the top section of the bezel door, slide the blue tab up to unlock the bezel media door
(slide the tab down when you want to lock it); then, grasp the pull-point area on the left side of the
media door and pull the door open.
.
Chapter 7 Installing and replacing FRUs
145