Installing A Memory Module - Lenovo TD200 - ThinkServer - 3809 Hardware Maintenance Manual

1
DIMM 1 (reserved)
2
DIMM 2
3
DIMM 3
4
DIMM 4 (reserved)
5
DIMM 5
6
DIMM 6
7
DIMM 7
8
DIMM 8
.
Attention: To avoid breaking the DIMM retaining clips or damaging the DIMM connectors, open
and close the clips gently.
Step 8. Carefully open the retaining clips on each end of the DIMM connector and remove the DIMM.
1
DIMM
2
Retaining clip
Step 9. If you are instructed to return the DIMM, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.

Installing a memory module

Note: If you are replacing a faulty DIMM, make sure that the replacement DIMM is the correct type of
memory. If you are adding DIMMs, install the DIMMs in the sequence indicated in this section.
The following notes describe the types of dual inline memory modules (DIMMs) that the server supports and
other information that you must consider when installing DIMMs (see "System-board option connectors" on
page 137 for the location of the DIMM connectors):
• The server supports industry-standard, 800, 1066, or 1333 MHz, PC3-10600R-999 (single-rank or
dual-rank) double-data-rate 3 (DDR3), registered, synchronous dynamic random-access memory
(SDRAM) dual inline memory modules (DIMMs) with error correcting code (ECC). For a list of supported
9
DIMM 9 (reserved)
10
DIMM 10
11
DIMM 11
12
DIMM 12 (reserved)
13
DIMM 13
14
DIMM 14
15
DIMM 15
16
DIMM 16
Chapter 7
.
Installing and replacing FRUs
211