Step 8.
Disconnect the tape drive cable from the system board.
Step 9.
Remove the screws that secure the tape drive
Step 10. Gently pull the drive out of the server.
Step 11. If you are instructed to return the tape drive, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Installing an optional tape drive
To install a optional full-high tape drive, complete the following steps.
Step 1.
Remove the EMC shields from the drive bay, if installed.
Step 2.
Touch the static-protective package that contains the tape drive to any unpainted metal surface on
the server; then, remove the tape drive from the package and place it on a static-protective surface.
Step 3.
Install the blue rails on the sides of the tape drive.
Step 4.
Align the rails on tape drive with the guides in the drive bay; then, slide the tape drive into the server
from the front of the server until it click into place.
1
to the server.
.
Chapter 7
Installing and replacing FRUs
171