Replacing The Virtual Media Key; Removing The Virtual Media Key; Installing The Virtual Media Key - Lenovo THINKSERVER RS210 Hardware Maintenance Manual

Replacing the virtual media key

To replace the virtual media key, complete the following procedures:

Removing the virtual media key

To remove the virtual media key, complete the following steps:
1. Read the safety information in "Important Safety Information" on page 1 and "Guidelines for trained
service technicians" on page 115.
2. Turn off the server and peripheral devices and disconnect all power cords; then, remove the cover
(see "Removing and installing the cover" on page 119).
3. Grasp the virtual media key 4 and gently slide it up and off of the mounting tab 2 .
Microprocessor
Heatsink
Orientation
DIMMs
DIMMs
4. If you are instructed to return the virtual media key, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.

Installing the virtual media key

To install the virtual media key, complete the following steps:
1. Read the safety information in "Important Safety Information" on page 1 and "Guidelines for trained
service technicians" on page 115.
2. Remove the cover (see "Removing and installing the cover" on page 119).
3. Align the virtual media key 4 with the mounting tab 2 and 1 ; then slide it down the tab onto
the connector 3 on the system board. Press the virtual media key down into the connector until it is
firmly seated on the system board.
Chapter 6. Replacing FRUs
167