Lenovo TD200 - ThinkServer - 3809 Hardware Maintenance Manual page 304

– NetworkSelect this choice to view or configure the network device options, such as iSCSI, PXE,
and network devices.
Note: The configuration forms for UEFI 2.1 and greater compliant add-on network devices might
be located here.
• Date and Time
Select this choice to set the date and time in the server, in 24-hour format (hour:minute:second).
This choice is on the full Setup Utility menu only.
• Start Options
Select this choice to view or boot to devices, including the startup sequence. The server starts from the
first boot record that it finds.
This choice is on the full Setup Utility menu only.
• Boot Manager
Select this choice to view, add, delete, or change the device boot priority, boot from a file, select a
one-time boot, or reset the boot order to the default setting.
• System Event Logs
Select this choice to enter the System Event Manager, where you can view the error messages in the
system event logs. You can use the arrow keys to move between pages in the error log.
The system event logs contain all event and error messages that have been generated during POST, by
the systems-management interface handler, and by the system service processor. Run the diagnostic
programs to get more information about error codes that occur. See Chapter 5 "Diagnostics" on page 21
for instructions for running the diagnostic programs.
Important: If the system-error LED on the front of the server is lit but there are no other error indications,
clear the IMM system-event log. Also, after you complete a repair or correct an error, clear the IMM
system-event log to turn off the system-error LED on the front of the server.
– POST Event Viewer
Select this choice to enter the POST event viewer to view the POST error messages.
– System Event Log
Select this choice to view the IMM system event log.
– Clear System Event Log
Select this choice to clear the IMM system event log.
• User Security
Select this choice to set, change, or clear passwords. See "Passwords" on page 297 for more information.
This choice is on the full and limited Setup Utility menu.
– Set Power-on Password
Select this choice to set or change a power-on password. See "Power-on password" on page 297
for more information.
– Clear Power-on Password
Select this choice to clear a power-on password. See "Power-on password" on page 297 for more
information.
– Set Administrator Password
Select this choice to set or change an administrator password. An administrator password is intended
to be used by a system administrator; it limits access to the full Setup Utility menu. If an administrator
password is set, the full Setup Utility menu is available only if you type the administrator password at
the password prompt. For more information, see "Power-on password" on page 297.
– Clear Administrator PasswordSelect this choice to clear an administrator password. For more
information, see "Passwords" on page 297s.
296
ThinkServer TD200 Hardware Maintenance Manual