1
Power supply
2
Power supply handle
Step 6.
Remove the air baffle (see "Removing the air baffle" on page 147).
Step 7.
Remove the fan cage assembly (see "Removing the fan cage assembly" on page 149).
Step 8.
Remove the heat sink and microprocessor. See "Removing the microprocessor and heat sink" on
page 187 for instructions; then, continue with step Step 9 "" on page 197.
Step 9.
Using a Phillips screwdriver, remove the four screws that secure the heat-sink retention module to
the system board; then, lift the heat-sink retention module from the system board.
1
Alignment triangle
.
Chapter 7
Installing and replacing FRUs
197