Lenovo TD200 - ThinkServer - 3809 Hardware Maintenance Manual page 243

1
Adapter connector for drives 0-3 signal cable
2
Signal cable for drives 0-3 (backplane labeled AD)
The following illustration shows the connectors on the controller to which you connect the signal
cables from the drive backplanes.
1
ServeRAID-MR10i controller
2
Adapter connector for drives 4-7 signal cable
3
Adapter connector for drives 0-3 signal cable
4
Battery
Connect one end of the other signal cable to the drive backplane for drive bays 4 through 7 and
route the other end of the cable through the plastic slots on the bottom of the chassis underneath
the fan cage assembly; then, connect it the ServeRAID-MR10i SAS/SATA controller as shown in the
following illustration:
.
Chapter 7 Installing and replacing FRUs
235