Remove The Security Bezel - Lenovo 7X19 Setup Manual

Installation procedures are presented in the optimal sequence to minimize work.
Attention: To ensure the installed components work correctly without problems, read the following
precautions carefully.
• Make sure the components you are installing are supported by your server. For a list of supported optional
components for the server, see
• Always download and apply the latest firmware. This will help ensure that any known issues are
addressed, and that your server is ready to work with optimal performance. download and apply the latest
firmware. This will help ensure that any known issues are addressed, and that your server is ready to work
with optimal performance. Go to
for your server.
• It is good practice to make sure that the server is working correctly before you install an optional
component.
• Follow the installation procedures in this section and use appropriate tools. Incorrectly installed
components can cause system failure from damaged pins, damaged connectors, loose cabling, or loose
components.

Remove the security bezel

Follow the instructions in this section to remove the security bezel.
Before removing the security bezel:
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. If the server is installed in a rack, slightly slide out or remove the server from the rack.
To remove the security bezel, complete the following steps:
Step 1. Insert the key that comes with the server and rotate it clockwise to unlock the security bezel to the
open position.
Figure 46. Unlocking the security bezel
Step 2. Press on the release latch and pivot the security bezel outward to remove it from the chassis.
ThinkSystem SR850 Setup Guide
86
https://serverproven.lenovo.com/
ThinkSystem SR850 Drivers and Software
52).
.
to download firmware updates
"Safety" on page iii and "Installation