Canon G3 Error Code List page 86

Chapter 2: Service Error Codes
##202 [ TX/RX ] The end of the procedure signal from the
Cause
• Large noise entered the line.
##203 [ TX/RX ] Mistake was made in operation caused by
Cause
• At changing transmission/reception or
polling, there was no document or record-
ing paper (only if between FAX-410Hs).
other party cannot be detected
Remedy
• Increase the number of final flag se-
quences
the other party may receive the procedure
signal correctly.
• Contact the telephone company, and re-
quest maintenance of the line.
a factor other than #003 through #008
Remedy
• Place a document or recording paper.
2-26
*9
for the procedure signal so that