Canon G3 Error Code List page 133

##343 [ TX/RX ] Ink absorber for ink detection has become
Cause
• The ink absorber for ink detection has be-
come full with waste ink.
full
Remedy
• Turn off and then on the power.
• If the waste ink in the ink absorber is ap-
parently not much, do not replace, but reg-
ister an approximate value once again as
the ink absorber capacity for ink detection
in service mode.
• If the waste ink is much, replace the ink
absorber, and set '0' as ink absorber capac-
ity for ink detection in service mode.
• Replace the printer control board; then,
check the ink absorber capacity, and regis-
ter an approximate value once again as the
ink absorber capacity for ink detection in
service mode.
• Replace the system control board; then,
check the ink absorber capacity, and regis-
ter an approximate value once again as the
ink absorber capacity for ink detection in
service mode.
2-73
Chapter 2: Service Error Codes