Canon G3 Error Code List page 110

Chapter 2: Service Error Codes
##291 [ TX ] In polling transmission, a signal other than
Cause
• The procedure signal has a fault.
##292 [ RX ] After transmitting CFR, EOL at the
• The line condition is poor, and EOL at the
beginning of the image signal cannot be
received correctly.
• The machine malfunctioned because of an
echo of CFR.
DTC was received while waiting for DTC
after receiving DTC for a 2nd time
Remedy
• Record the protocol on a DAT or MD, and
have it analyzed by the local Canon office
and/or Technical Center.
beginning of the image signal cannot be
received for 5 sec
Remedy
• Ask the operator of the other party to in-
crease the transmission level
may be received correctly.
• Ask the operator of the other party to de-
crease the transmission start speed.
• Adjust the NL equalizer
be received correctly.
• Provide echo remedy 3
• Decrease the transmission level
an echo of CFR will not be received.
2-50
*1
so that EOL
*2
so that EOL may
*7
.
*1
so that