Canon G3 Error Code List page 272

Chapter 2: Service Error Codes
##1618 [ TX/RX ] Fault occurred for layer 6
Cause
• A fault (image end not detected, MMR
frame formatting fault, etc.) occurred in the
communication protocol for layer 6 (prepa-
ration layer).
##1619 [ RX ] Specified function is not offered
Cause
• The function specified for the terminal of
the transmitting machine is not offered.
Remedy
• Start a communication once again.
• Print out a communications analysis list,
and analyze it.
Remedy
• Ask the operator of the other party to try
once again using a different communica-
tion mode.
• Print out a communications analysis list,
and analyze it.
2-212