Canon G3 Error Code List page 263

##1417 [ TX ] Timer used to wait for a response went ON
Cause
• There was no reply from the receiving ma-
chine, and the timer used to wait for a re-
spond (T.62 T2 timer) went ON. This fault
occurs when the signal is destroyed by
noise or the like.
##1418 [ TX/RX ] CSA timer went ON
Cause
• CSA was transmitted, but there was no re-
sponse from the receiving machine, caus-
ing the CSA timer (T.62 T3 timer) to go
ON. This fault occurs when the signal is
destroyed by noise or the like.
Chapter 2: Service Error Codes
Remedy
• Check to find out if the terminal of the re-
ceiving party is operating normally, and
start a communication once again.
• Print out a communications analysis list,
and analyze it.
Remedy
• Check to find out that the terminal of the
other machine is operating normally, and
start a communication once again.
• Print out a communications analysis list,
and analyze it.
2-203