Canon G3 Error Code List page 150

Chapter 2: Service Error Codes
##670 [ TX ] In V.8 late start, the V.8 ability was detected
Cause
• CI was transmitted, but the other party
failed to receive it correctly and disconnect
the line.
• ANSam or DIS from the other party can-
not be received correctly.
##671 [ RX ] In V.8 call arrives, the procedure fails to
• In phase 1, the other party cannot receive
the signal correctly and disconnect the line.
• In phase 1, the signal from the other party
cannot be received correctly.
in DIS from the other party and, in
response, CI was transmitted; however, the
procedure failed to advance, causing a T1
time-over condition
Remedy
• Increase the transmission level
other party may receive CI correctly.
• Prohibit the V.8/V.34 procedure.
• Ask the operator of the other party to in-
crease the transmission level
signal may be received correctly.
• Prohibit the V.8/V.34 procedure.
advance to phase 2 after CM detection,
causing a T1 time-over condition
Remedy
• Increase the transmission level
other party may receive the signal correctly.
• Prohibit the V.8/V.34 procedure.
• Ask the operator of the other party to in-
crease the transmission level
signal may be received correctly.
• Prohibit the V.8/V.34 procedure.
2-90
*1 so that the
*1
so that the
*1
so that the
*1
so that the