Canon G3 Error Code List page 64

Chapter 2: Service Error Codes
##007 [ TX ] In G2 transmission, CFR2 cannot be
Cause
• The line condition is poor, and CFR2 can-
not be received correctly.
• The other party has run out of recording
paper.
##008 [ RX ] In G2 reception, GC2, PIS, or phase signal
Cause
• The line condition is poor, and the signal
immediately before the GC2, PIS, or phase
signal cannot be received.
received
Remedy
• Ask the operator of the other party to in-
crease the transmission level
may be received correctly.
• Adjust the NL equalizer
may be received correctly.
• Ask the operator of the other party to set
recording paper.
cannot be received for 35 sec and a
different signal is received
Remedy
• Ask the operator of the other party to in-
crease the transmission level
signal immediately before GC2, PIS, or
phase signal may be received correctly.
• Adjust the NL equalizer
nal immediately before GC2, PIS, or phase
signal may be received correctly.
2-4
*1
so that CFR2
*2
so that CFR2
*1
so that the
*2
so that the sig-