Canon G3 Error Code List page 23

Chapter1: User Error Codes
#018 [ TX ] Auto dialing transmission error
Cause
• The tone/pulse setting is wrong.
• The connection time for the line is too long.
• The line of the other party was engaged.
• The other party is not connected to the line,
or is not turned on so that the transmission
did not arrive.
• The other party is not a facsimile machine.
• The other party ran out of recording paper
so that the line was disconnected during
the pre-procedure.
• The 2nd dial tone does not arrive for trans-
mission to F-NET (Facsimile communica-
tion network services). [Japanese model]
• The machine was disconnected from the
line using an unidentified reason code.
• The other party did not respond.
• The other party is out of order.
• The other party is out of use for some reason.
• The exchange is congested.
• There is no line/channel that is available at
present.
• The requested line/channel cannot be used
on the side of the other party.
• Calls crashed.
• Communication is not possible at present
by reason of terminal management.
Remedy
• Make the correct tone/pulse setting.
• When registering an auto-dial number, put
a relatively long pause at the end of the
telephone number to delay the start of the
T0 timer.
• Increase the T0 timer setting
time-over condition.
• Start a call once again.
• Ask the operator of the other party to find
out the cause.
• Check the number of the other party, and
start a call once again.
• Ask the operator of the other machine to
set recording paper.
• Check to make sure that a subscription has
been signed for F-NET, and inform the tele-
phone company that the line is out of order.
• Wait for a while, and start a call once again.
• Check to make sure that the other party is
tuned on.
• Ask the operator of the other party to find
out the cause.
1-10
*4 to prevent a