Canon G3 Error Code List page 85

Cause
• In polling reception of Canon mode, the
password is not correct.
• In polling transmission, document is not
placed.
• The other party transmitted, but there is no
recording paper.
• The line condition is poor, and the other
party cannot receive the procedure signal
correctly.
• The machine malfunctioned because of an
echo.
• The image signal or the Q signal cannot be
received, and the other party suffered an
excess number of re-transmissions of the
procedure signal.
• The line condition is poor, anad the other
party (transmitting machine) cannot use
fall-back.
Chapter 2: Service Error Codes
Remedy
• If the other party is a Canon machine, con-
tact the operator to match the passwords.
• If the other party is a non-Canon machine,
contact the operator, and ask to set the
machine so that it will execute polling
transmission without any condition.
• Place a document, and ask the operator of
the other party to make a call once again.
• Set recording paper.
• Increase the transmission level
other party may receive the procedure sig-
nal correctly.
• Adjust the NL equalizer
party may receive the procedure signal cor-
rectly.
• Provide echo remedies 1, 2, or 3
• Decrease the transmission level
an echo will not be received.
• Ask the operator of the other party to in-
crease the transmission level
signal may be received correctly.
• Adjust the NL equalizer
nal may be received correctly.
• Ask the operator of the other party to de-
crease the transmission start speed.
• Ask the operator of the other party to in-
crease the transmission level
signal may be received correctly.
• Adjust the NL equalizer
nal may be received correctly.
• Loosen the RTN transmission conditions
so that RTN will not be transmitted.
2-25
*1 so that the
*2
so that the other
*7
.
*1 so that
*1
so that the
*2
so that the sig-
*1
so that the
*2
so that the sig-
*6