Canon G3 Error Code List page 77

##109 [ TX ] After transmitting DCS, a signal other than
Cause
• The procedure signal is faulty.
##110 [ TX ] PIS was detected during image
Cause
• The other party released the line.
DIS, DTC, FTT, CFR, and CRP was received,
exceeding the permitted number of
transmissions of the procedure signal
Remedy
• Record the protocol on a DAT or MD, and
have it analyzed by the local Canon office
and/or Technical Center.
transmission
Remedy
• Transmit once again.
2-17
Chapter 2: Service Error Codes