Canon G3 Error Code List page 71

##100 [ TX ] The number allowed for retransmission of
Cause
• The transmission level is too low, and the
other party cannot receive NSS, TSI, DCS,
TCF, or the training signal correctly.
• After transmission of TCF immediately
before the image signal, the other party
malfunctioned because of an echo.
• After transmission of the Q signal follow-
ing the image signal, the line condition
became poor so that the other party cannot
receive the image signal or the Q signal
correctly.
the procedure signal was exceeded during
transmission
Remedy
• Increase the transmission level
other party may receive the signal correctly.
• Ask the operator of the other party to pro-
vide echo remedy 3
• Using a manual call, press the Start button
after hearing the 1st DIS from the other
party.
• To prevent response to the 1st DIS from
the other party, put a relatively long pause
to the telephone number when registering
an auto-dialing number.
• Increase the transmission level
other party may service the image signal
or the Q signal correctly.
• Decrease the transmission start speed.
• Adjust the NL equalizer
party may receive the image signal or the
Q signal correctly.
• Add an echo protect tone to the V.29 mo-
dem signal for transmission
• Increase the number of final flag se-
quences
the other party may receive the procedure
signal correctly.
2-11
Chapter 2: Service Error Codes
*7
.
*2
so that the other
*8
.
*9 for the procedure signal so that
*1
so that the
*1
so that the