Canon G3 Error Code List page 180

Chapter 2: Service Error Codes
##776 [ TX ] In ECM transmission, a signal other than
Cause
• The procedure signal is faulty.
##777 [ TX ] In ECM transmission, DCN was received
Cause
• The line condition is poor, and the other
party cannot receive EOR-MPS correctly.
• The Stop key was pressed during a com-
munication.
ERR was received after transmission of
EOR-MPS
Remedy
• Record the protocol on a DAT or MD, and
have it analyzed by the local Canon office
and/or Technical Center.
after transmission of EOR-MPS
Remedy
• Increase the transmission level
other party may receive EOR-MPS cor-
rectly.
• Adjust the NL equalizer
party may receive EOR-MPS correctly.
• Add an echo protect tone to the V.29 mo-
dem signal for transmission
• Transmit once again.
2-120
*1
so that the
*2
so that the other
*8 .