Use The Device View; Configure Snmp; Configure The Snmpv1/V2 Community - NETGEAR ProSafe XS728T User Manual

ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
Table 14. Green Ethernet Statistics Summary information (continued)
Field
Short Reach Admin mode
Short Reach Operational Status
EEE Admin mode

Use the Device View

For device view information, see
on page 20.

Configure SNMP

You can configure SNMP settings for SNMPv1/v2 and SNMPv3. The switch software
supports the configuration of SNMP groups and users that can manage traps that the SNMP
agent generates.
The switch uses both standard public MIBs for standard functionality and private MIBs that
support additional switch functionality. All private MIBs begin with a hyphen (-) prefix. The
main object for interface configuration is in -SWITCHING-MIB, which is a private MIB. Some
interface configurations also involve objects in the public MIB, IF-MIB.
From the System > SNMP menu, you can access pages that are described in the following
sections:
•

Configure the SNMPv1/v2 Community

• Configure SNMPv1/v2 Trap Settings
• Configure SNMPv1/v2 Trap Flags
• View the Supported MIBs
• Configure SNMPv3 Users
Configure the SNMPv1/v2 Community
Only the communities that you define can access to the switch using the SNMP V1 and
SNMP V2 protocols. Only those communities with read/write level access can be used to
change the configuration using SNMP.
Description
Enable or disable Short Reach Admin mode on the port. With Short
Reach mode enabled, PHY is forced to operate in low power mode
irrespective of the cable length.
Current operational status of the Short Reach mode.
Enable or disable Energy Efficient Ethernet mode on the port. With
EEE mode enabled, the port transitions to low power mode during link
idle conditions.
Web Browser–Based Management Interface Device View
on page 59
on page 62
on page 64
on page 65
on page 66
Configure System Information
59