Modifying Configuration Settings; Section 3.5, "Modifying Configuration Settings - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ADMINISTRATION QUICK START 10.3 Quick Start Manual

6 Using the Assigned Rights panel, modify the assigned rights.
For information about the options on the page, click the Help button, or see
Administrator
Reference.
7 When you have finished modifying the rights, click Apply to save the changes.
For more information about creating ZENworks administrator accounts or administrator roles, see
"Administrators" in the
Reference.
You can also use the
administrator account. For more information, see
Configuration Management Command Line Utilities

3.5 Modifying Configuration Settings

The Management Zone configuration settings enable you to control a wide range of functionality
behavior for you zone. There are Content settings that let you control when content can be
distributed to devices and how often content is replicated between ZENworks Servers (if you have
multiple servers). There are Device Management settings that let you control how often devices
access a ZENworks Server for refreshed information, how often dynamic groups are refreshed, and
what levels of messages (informational, warning, or error) are logged by the ZENworks Adaptive
Agent. There are Event and Messaging settings, Discovery and Deployment settings, and much
more.
Management Zone settings that apply to devices are inherited by all devices in the zone. As
discussed in
zone settings by configuring them on device folders or on individual devices. This allows you to
establish zone settings that apply to the largest number of devices and then, as necessary, override
the settings on folders and devices.
36 ZENworks 10 Configuration Management Administration Quick Start
Rights" in the ZENworks 10 Configuration Management System Administration
ZENworks 10 Configuration Management System Administration
command in the zman utility to create a ZENworks
admin-create
Section 3.1, "Organizing Devices: Folders and Groups," on page
"Administrator Commands" in the
Reference.
"Managing
ZENworks 10
21, you can override