High-Performance Configurations For Crystal; Increasing The Report Refresh Record Limit For Crystal Reports Server - Novell SENTINEL 6.1 SP2 - INSTALLATION GUIDE 02-2010 Installation Manual

<hostname_or_IP_of_web_server> must be replaced with the IP address or hostname of
Crystal Reports Server. The URL does not work as expected if the Automated Process
Scheduler (APS) is set to the IP address. It must be the host name of Crystal Reports Server.
4 Click Refresh, which is next to the Analysis URL field.
5 If you have Advisor installed, provide the following in the Advisor URL field:
http://<hostname_or_IP_of_web_server>/
GetReports.asp?APS=<hostname>&user=Guest&password=&tab=Advisor
<hostname_or_IP_of_web_server> must be replaced with the IP address or hostname of
Crystal Reports Server. The URL above does not work as expected if the APS is set to the IP
address. It must be the host name of Crystal Reports Server.
6 Click Refresh, which is next to the Advisor URL field, then click Save.
7 Log out and log in to the Sentinel Control Center. The Crystal Report trees in the Analysis tab
and Advisor tab (if Advisor is installed) are displayed in the Navigator window.

7.9 High-Performance Configurations for Crystal

Section 7.9.1, "Increasing the Report Refresh Record Limit for Crystal Reports Server," on

page 122
 Section 7.9.2, "Using the Aggregration Service for Reports," on page 123
Section 7.9.3, "Report Development," on page 124

7.9.1 Increasing the Report Refresh Record Limit for Crystal
Reports Server
Depending on the number of events that Crystal Reports is querying, you might get an error on the
maximum processing time or maximum record limit. To set your server to process a higher number
or an unlimited number of records, you must reconfigure the Crystal Page Server by using either the
Central Configuration Manager or the Crystal Web Page.
"Using the Central Configuration Manager to reconfigure the Crystal Page Server" on page 122

 "Using the Central Management Console to reconfigure the Crystal Page Server" on page 123
Using the Central Configuration Manager to reconfigure the Crystal Page Server
1 Click Start > All Programs > BusinessObjects 11 > Crystal Reports Server > Central
Configuration Manager.
2 Right-click Crystal Reports Page Server, then select Stop.
3 Right-click Crystal Reports Page Server, then select properties.
4 In the Command field in the Properties tab, at the end of the command line add:
maxDBResultRecords <value greater than 20000 or 0 to disable the default
limit>
5 Restart the Crystal Page Server.
122 Sentinel 6.1 Installation Guide