Mrcp Tts Provider Configuration; Add A New Mrcp Tts Provider - Cisco CRS-1 - Carrier Routing System Router Administration Manual

Chapter 15 The Subsystems Menu

MRCP TTS Provider Configuration

Add a New MRCP TTS Provider

Use one or more of the following MRCP TTS Configuration hyperlinks:
MRCP TTS Providers—to configure information about the vendor of your
•
TTS system (see Provisioning MRCP TTS Providers, page
MRCP TTS Servers—to configure your the TTS server's name, port
•
location, and available languages (see
page 3-30).
MRCP TTS Default Genders—to configure the default gender setting for
•
the Locales specified during TTS Server provisioning (see
MRCP TTS Default Genders, page
You will need at least one MRCP TTS Provider for each vendor you will be
installing TTS servers for. If you install both ScanSoft and Nuance MRCP TTS
Servers, you will need at least two Providers.
Use the MRCP TTS Provider Configuration web pages to display, add, modify,
and delete information about your TTS Provider.
On any MRCP TTS Configuration web page, click the MRCP TTS Provider
hyperlink on the navigation bar to access the MRCP TTS Providers Configuration
summary web page.
To modify an existing MRCP TTS Provider, click any hyperlink within the
provider's summary table entry; the MRCP TTS Provider Configuration web page
opens.
To reload all configured MRCP TTS Provider information, click Refresh All.
To access the MRCP TTS Provider Configuration page, click the Add MRCP
TTS Provider hyperlink.
Cisco Customer Response Solutions Administration Guide, Release 4.1(1)
The MRCP TTS Menu Option
Provisioning MRCP TTS Servers,
3-32).
3-29).
Provisioning
15-23