Cisco CRS-1 - Carrier Routing System Router Administration Manual page 272
Customer response solutions release 4.1(1)
Hide thumbs
Also See for CRS-1 - Carrier Routing System Router:
- Getting started manual (289 pages) ,
- Troubleshooting manual (264 pages) ,
- Migration manual (250 pages)
Table of Contents
Advertisement
Cisco CRS Utilities
Scenario 4: CRS Node with Third-Party Servers for ASR and TTS
Cisco Customer Response Solutions Administration Guide, Release 4.1(1)
8-52
this dialog box. Then modify the IP address under the appropriate
subsequent screens (such as Unified CM, VoIP Network Device and
service IP address).
Follow Scenario 1's Steps 6.a, 6.b, and 6.e.
b.
9.
For Node 4 (VoIP)
a.
Run the Cisco Agent Desktop Configuration Setup by double clicking the
PostInstall.exe file (located under C:\Program files\Cisco\Desktop\bin)
and modify the IP address of the Primary/Secondary CAD Directory
Service, click OK,
You will get an error message "
Service. Do you want to try it again? The process may take time.
Press Yes to retry Directory Service connection. Press No to
proceed without Directory Service functionality.
this dialog box. Then modify the IP address under the appropriate
subsequent screens (such as Unified CM, VoIP Network Device and
service IP address).
Follow Scenario 1's Steps 6.a, 6.b, and 6.e.
b.
10.
For Node 5 (RDB), follow Scenario 1's Steps 6.a and 6.e.
For Node 6 (RDB), follow Scenario 1's Steps 6.a and 6.e.
11.
12.
Finally, reboot all the nodes.
In a deployment consisting of a CRS node with third party servers for MRCP ASR
and MRCP TTS, do the following to update the IP address on the nodes in the
cluster:
If you change the IP address for any of the nodes within the CRS cluster,
1.
follow the instructions in the previous scenarios.
Changing the IP address of the CRS node does not affect the third party
2.
MRCP ASR and MRCP TTS servers. Apart from the instructions in the
previous scenarios, no other change is required.
3.
If you change the IP address of the third party server(s) that hosts the ASR
and/or TTS server software from the MRCP vendors, you will need to update
the server configuration data in the App Admin pages for the MRCP ASR
and/or MRCP TTS subsystems.
Chapter 8
Managing the Cisco CRS System
Error connecting to Directory
" Click No in
Advertisement
Table of Contents
