Configuring A Unique Local Ipv6 Unicast Address; Modifying An Ipv6 Interface; Removing An Ipv6 Interface - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Software release 6
Hide thumbs Also See for OmniSwitch 6850-48:
Table of Contents

Advertisement

Configuring an IPv6 Interface
To create an IPv6 interface for a 6to4 tunnel, use the following command:
-> ipv6 interface v6if-6to4 tunnel 6to4
Use the
show ipv6 interface
mation about this command, see the OmniSwitch CLI Reference Guide.

Configuring a Unique Local IPv6 Unicast Address

The
ipv6 address global-id
value can be manually specified or automatically generated:
-> ipv6 address global-id generate
-> ipv6 address global-id 32:57a3:8fed
Once the global ID is generated the
local address using the configured global-id.

Modifying an IPv6 Interface

The ipv6 interface command is also used to modify existing IPv6 interface parameter values. It is not
necessary to first remove the interface and then create it again with the new values. The changes specified
will overwrite existing parameter values. For example, the following command changes the router adver-
tisement (RA) reachable time and the RA retransmit timer values for interface v6if-v200:
-> ipv6 interface v6if-v200 ra-reachable-time 60000 ra-retrans-time 2000
When an existing interface name is specified with the ipv6 interface command, the command modifies
specified parameters for that interface. If an unknown interface name is entered along with an existing
VLAN or tunnel parameter, a new interface is created with the name specified.

Removing an IPv6 Interface

To remove an IPv6 interface from the switch configuration, use the no form of the ipv6 interface
command. Note that it is only necessary to specify the name of the interface, as shown in the following
example:
-> no ipv6 interface v6if-v200
page 26-14
command to verify the interface configuration for the switch. For more infor-
command is used to create a new value for the global ID. A 5-byte global ID
ipv6 address local-unicast
OmniSwitch AOS Release 6 Network Configuration Guide
command can be used to generate a unique
Configuring IPv6
September 2009

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents