Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual page 480

Modifying Dynamic Link Aggregate Group Parameters
For example, to modify the port priority of dynamic aggregate partner port 3 in slot 4 to 100 you would
enter:
-> lacp agg 4/3 partner admin port priority 100
As an option, you can use the ethernet, fastethernet, and gigaethernet keywords before the slot and port
number to document the interface type or make the command look consistent with early-generation
Alcatel-Lucent CLI syntax. For example, to modify the port priority of dynamic aggregate partner port 3
in slot 4 to 100 and document that the port is a Giga Ethernet port you would enter:
-> lacp agg gigaethernet 4/3 partner admin port priority 100
Restoring the Partner Port Priority
To remove a user-configured partner port priority from a dynamic aggregate group partner port's configu-
ration use the no form of the
slot number, a slash (/), the port number, and no partner admin port priority.
For example, to remove a user-configured partner port priority from dynamic aggregate partner port 3 in
slot 4 you would enter:
-> lacp agg 4/3 no partner admin port priority
page 23-28
lacp agg partner admin port priority
OmniSwitch AOS Release 6 Network Configuration Guide
Configuring Dynamic Link Aggregation
command by entering lacp agg, the
September 2009