Mpls Defaults - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring MPLS

MPLS Defaults

The following table shows the default settings of the configurable LDP-based MPLS parameters.
Parameter Description
MPLS status for the switch.
LDP status for the switch.
Default hello (hold) timeout and hello
interval for all LDP interfaces on the
switch.
Default keepalive timeout and kee-
palive interval for all LDP interfaces
on the switch.
Transport address used to set up LDP
TCP sessions.
Global hello (hold) timeout and hello
interval for targeted LDP sessions.
Global keepalive timeout and kee-
palive interval for targeted LDP ses-
sions.
Graceful restart helper status.
The amount of time that neighboring
LDP routers should wait before
attempting to reconnect to the LDP
router after a graceful restart.
The amount of time that the LDP
router retains its MPLS forwarding
state after a graceful restart.
The amount of time the LDP router
retains stale MPLS label-FEC bind-
ings received from a neighboring
LDP router as the result of a graceful
restart process.
The amount of time the LDP router
will wait for a neighboring router to
re-establish an LDP session.
OmniSwitch AOS Release 6 Network Configuration Guide
Command
configure router mpls shutdown
configure router ldp shutdown
configure router ldp interface-
parameters hello
configure router ldp interface-
parameters keepalive
configure router ldp interface-
parameters transport-address
configure router ldp targeted-
session hello
configure router ldp targeted-
session keepalive
configure router ldp graceful-
restart-helper
configure router ldp reconnect-
time
configure router ldp fwd-state-
holding-time
configure router ldp maximum-
recovery-time
configure router ldp neighbor-
liveness-time
September 2009
MPLS Defaults
Default Value/Comments
Enabled
Enabled
15 second hello timeout
3 second factor value
5 second hello interval
30 second keepalive timeout
3 second factor value
10 second keepalive interval
System (Loopback0) IP
address
45 second hello timeout
3 second factor value
15 second hello interval
40 second keepalive timeout
4 second factor value
10 second keepalive interval
Disabled
120 seconds
120 seconds
120 seconds
120 seconds
page 10-3