Configuring RIP
Verifying the RIP Configuration
A summary of the show commands used for verifying the RIP configuration is given here:
show ip rip
show ip rip routes
show ip rip interface
show ip rip peer
show ip redist
For more information about the displays that result from these commands, see the OmniSwitch CLI Refer-
ence Guide.
OmniSwitch AOS Release 6 Network Configuration Guide
Displays the RIP status and general configuration parameters (e.g.,
forced hold-down timer).
Displays the RIP routing database. The routing database contains all
the routes learned through RIP.
Displays the RIP interface status and configuration.
Displays active RIP neighbors (peers).
Displays the currently configured RIP redistribution filters.
September 2009
Verifying the RIP Configuration
page 28-19