Creating And Deleting A Dynamic Aggregate Group; Creating A Dynamic Aggregate Group; Deleting A Dynamic Aggregate Group - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring Dynamic Link Aggregation

Creating and Deleting a Dynamic Aggregate Group

The following subsections describe how to create and delete dynamic aggregate groups with the
linkagg size command.

Creating a Dynamic Aggregate Group

To configure a dynamic aggregate group, enter lacp linkagg followed by the user-configured dynamic
aggregate number (which can be from 0 to 31), size, and the maximum number of links that will belong to
this dynamic aggregate group, which can be 2, 4, or 8. For example, to configure the dynamic aggregate
group 2 consisting of eight links enter:
-> lacp linkagg 2 size 8
You can create up to 32 link aggregation (both static and dynamic) groups per a standalone switch or a
stack of switches. In addition, you can also specify optional parameters shown in the table below. These
parameters must be entered after size and the user-specified number of links.
lacp linkagg size keywords
name
actor system priority
partner system priority
For example, Alcatel-Lucent recommends assigning the actor admin key when you create the dynamic
aggregate group to help ensure that ports are assigned to the correct group. To create a dynamic aggregate
group with aggregate number 3 consisting of two ports with an admin actor key of 10, for example, enter:
-> lacp linkagg 3 size 2 actor admin key 10
Note. The optional keywords for this command may be entered in any order as long as they are entered
after size and the user-specified number of links.

Deleting a Dynamic Aggregate Group

To remove a dynamic aggregation group configuration from a switch use the no form of the
size command by entering no lacp linkagg followed by its dynamic aggregate group number.
For example, to delete dynamic aggregate group 2 from a switch's configuration you would enter:
-> no lacp linkagg 2
Note. You cannot delete a dynamic aggregate group if it has any attached ports. To remove attached ports
you must disable the dynamic aggregate group with the
described in "Disabling a Dynamic Aggregate Group" on page
OmniSwitch AOS Release 6 Network Configuration Guide
admin state enable
admin state disable
actor system id
lacp linkagg admin state
September 2009
Configuring Dynamic Link Aggregate Groups
partner admin key
actor admin key
partner system id
command, which is
23-15.
lacp
lacp linkagg
page 23-11