Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual page 460

Dynamic Link Aggregation Overview
1
. Local (actor) switch sends
requests to establish a
dynamic aggregate group link
to the remote (partner)
switch.
2
. Partner switch acknowl-
edges that it can accept this
dynamic group.
3
. Actor and partner switches
negotiate parameters for the
dynamic group, producing
optimal settings.
4
. Actor and partner switches
establish the dynamic aggre-
gate group. LACPDU mes-
sages are sent back and forth
to monitor and maintain the
group.
Dynamic aggregate groups can be created between each of the following OmniSwitch products:
•
two OmniSwitch 6400, 6800, 6850, 6855, or 9000 switches.
•
an OmniSwitch 6400, 6800, 6850, 6855, or 9000 switch and an OmniSwitch 7700/7800, OmniSwitch
8800, or OmniSwitch 6600 Series switch.
•
an OmniSwitch 6400, 6800, 6850, 6855, or 9000 switch and an early-generation Alcatel-Lucent switch,
such as an Omni Switch/Router.
•
an OmniSwitch 6400, 6800, 6850, 6855, or 9000 switch and another vendor's switch if that vendor
supports IEEE 802.3ad LACP.
See "Configuring Dynamic Link Aggregate Groups" on page 23-10
Line Interface (CLI) commands to configure dynamic aggregate groups and see
Link Aggregation Configuration and Statistics" on page 23-32
tor dynamic aggregate groups.
page 23-8
Local (Actor) Switch
Example of a Dynamic Aggregate Group Network
OmniSwitch AOS Release 6 Network Configuration Guide
Configuring Dynamic Link Aggregation
Remote (Partner) Switch
Dynamic Group
for information on using Command
"Displaying Dynamic
for information on using the CLI to moni-
September 2009