Vpls Specifications - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

VPLS Specifications

VPLS Specifications
IETF Internet-Drafts Supported
RFCs Supported
Platforms Supported
Maximum number of service instances
(VPLS) per system
Maximum number of pseudo wires/VCs per
system
Maximum number of Service Access Points
(SAPs) and service bindings (virtual ports)
Maximum number of Service Distribution
Point (SDP) sessions.
Maximum number of LDP/Target LDP
neighbors
Maximum number of LDP/Target LDP ses-
sions
Maximum number of LSP tunnels (push/pop
entries)
Maximum number of LSP swap entries
Maximum number of static LSPs
Maximum number of backup static LSPs
*Applies to egress and ingress Label Edge Routers (LERs) only.
**Applies to transit Label Switching Routers (LSRs) only.
page 11-2
draft-ietf-bfd-base-08.txt — Bidirectional Forward-
ing Detection
draft-ietf-bfd-v4v6-1hop-08.txt — BFD for IPv4
and IPv6 (Single Hop)
3031–Multiprotocol Label Switching Architecture
3036–Label Distribution Protocol Specification
3478–Graceful Restart Mechanism for LDP.
4762–Virtual Private LAN Service (VPLS) using
LDP Signaling.
OmniSwitch 9000E
1024*
8K*
8192*
32
32*
32*
32*
32**
1024
16
OmniSwitch AOS Release 6 Network Configuration Guide
Configuring VPLS
September 2009