Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual page 650

BFD Application Example
•
To verify the configured BFD status on routers, use the
shows the protocols registered for BFS (OSPF in example network) and the parameter values for the
transmit, receive, and echo intervals, the multiplier number, and the operational mode.
•
To check the BFD status on all interfaces, use the
command displays the interfaces participating in the BFD sessions, the IP addresses associated with the
interface, and respective BFD session parameters.
•
To check the BFD status on an individual interface, use the
along with the interface name.
•
To display information about BFD sessions, use the
•
To check the BFD status at the OSPF protocol level, use the
also used to check the general OSPF configuration. For OSPF interfaces, use the
face command.
page 30-30
show ip bfd-std interfaces
show ip bfd-std sessions
OmniSwitch AOS Release 6 Network Configuration Guide
show ip bfd-std command. This command
command. This
show ip bfd-std interfaces
command.
show ip ospf command. This command is
Configuring BFD
command
show ip ospf inter-
September 2009