Configuring Autonegotiation And Crossover Settings; Enabling And Disabling Autonegotiation - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Setting Ethernet Parameters for Non-Combo Ports
-> interfaces 2/20 ifg 10
To configure the inter-frame gap on a range of ports, enter interfaces, followed by the slot number, a slash
(/), the first port number, a hyphen (-), the last port number, ifg, and the desired inter-frame gap value. For
example, to set the inter-frame gap value on ports 20 through 22 on slot 2 to 10 bytes, enter:
-> interfaces 2/20-22 ifg 10
Note. Since the interfaces ifg command is only supported on Gigabit interfaces, only the gigaethernet
keyword should be used.

Configuring Autonegotiation and Crossover Settings

The following subsections describe how to enable and disable autonegotiation (see
Disabling Autonegotiation" on page
Settings" on page 1-19).

Enabling and Disabling Autonegotiation

By default, autonegotiation is enabled. To enable or disable autonegotiation on a single port, a range of
ports, or an entire slot, use the
page 1-19 and "Setting Ethernet Combo Port Parameters" on page 1-21
To enable or disable autonegotiation on an entire switch, enter interfaces, followed by the slot number,
autoneg, and either enable or disable. For example, to enable autonegotiation on slot 2, enter:
-> interfaces 2 autoneg enable
To enable or disable autonegotiation on a single port, enter interfaces, followed by the slot number, a
slash (/), the port number, autoneg, and either enable or disable. For example, to enable autonegotiation
on port 3 on slot 2, enter:
-> interfaces 2/3 autoneg enable
To enable or disable autonegotiation on a range of ports, enter interfaces, followed by the slot number, a
slash (/), the first port number, a hyphen (-), the last port number, autoneg, and either enable or disable.
For example, to enable autonegotiation on ports 1 through 3 on slot 2, enter:
-> interfaces 2/1-3 autoneg enable
Note. Please refer to
tion.
page 1-18
1-18) and configure crossover settings (see
interfaces autoneg
"Autonegotiation Guidelines" on page 1-8
OmniSwitch AOS Release 6 Network Configuration Guide
command. (See "Configuring Crossover Settings" on
for more information).
for guidelines on configuring autonegotia-
Configuring Ethernet Ports
"Enabling and
"Configuring Crossover
September 2009