Displaying Source Learning Information - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Managing Source Learning

Displaying Source Learning Information

To display MAC Address Table entries, statistics, and aging time values, use the show commands listed
below:
show mac-address-table
show mac-address-table static-
multicast
show mac-address-table count
show mac-address-table aging-time
show source-learning chassis-
distributed
For more information about the resulting displays from these commands, see the OmniSwitch CLI Refer-
ence Guide. An example of the output for the show mac-address-table and show mac-address-table
aging-time commands is also given in
OmniSwitch AOS Release 6 Network Configuration Guide
Displays a list of all MAC addresses known to the MAC address
table, including static MAC addresses.
Displays a list of all static multicast MAC addresses known to the
MAC address table. Note that only static multicast addresses
assigned to ports that are up and enabled are displayed with this
command.
Displays a count of the different types of MAC addresses (learned,
permanent, reset, and timeout). Also includes a total count of all
addresses known to the MAC address table.
Displays the current MAC address aging timer value by switch or
VLAN.
Displays the current status of the distributed MAC source learning
mode.
"Sample MAC Address Table Configuration" on page
September 2009
Displaying Source Learning Information
2-3.
page 2-11