Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual page 946

Policy Applications
For example:
In this scenario, traffic from the firewall is sent back to the switch to be re-routed. But because the traffic
re-enters the switch through a port that is not in the Slot01 port group, the traffic does not match the
Redirect_All policy and is routed normally through the switch.
-> policy condition Traffic3 source ip 10.3.0.0 mask 255.255.0.0 source port
group Slot01
-> policy action Firewall permanent gateway ip 173.5.1.254
-> policy rule Redirect_All condition Traffic3 action Firewall
Make sure to enter the qos apply command to activate the policy rule on the switch. Otherwise the rule
will be saved as part of the pending configuration, but will not be active.
page 40-64
10.3.0.0
OmniSwitch
Using a Built-In Port Group
OmniSwitch AOS Release 6 Network Configuration Guide
173.10.2.0
Firewall
173.5.1.0
Configuring QoS
174.26.1.0
173.5.1.254
September 2009